22
The slave units can be radio-enabled speedlites
and set on slave mode, and also other Canon
ETTL ashes non-radio-enabled by using with
the Phottix Laso Receiver.
Master Unit
Phottix Laso
Transmitter
Canon Speedlites that have a
wireless flash shooting function
using radio transmission, like
600EX-RT (Slave mode).
Phottix Laso Receiver+Canon
ETTL Flash (Non-wireless mode)
Slave Unit
Note:
1) When using the Phottix Laso
Receiver as
slave unit, restrictions will apply to parts of its
functions and operations. For details, see the
instruction manual of Phottix Laso
Receiver
2) When performing radio transmission
wireless ash shooting, restrictions may apply
to the ash mode, maximum ash sync speed
(referred to below as the “ash sync speed”)
and high-speed sync function, depending on
the camera used.
Wireless Settings
To perform wireless shooting, set the Phottix
Laso Transmitter (master unit) and ash (slave
unit) with the following procedure.
1. Master unit setting: Check that
is displayed.
2. Slave unit setting: For the slave unit setting,
see the ash or Receiver’s instruction manual.
To Next Page
Loading...
