Phottix Laso - Modeling Flash

14
a slave unit. For operations, see the ash’s
instruction manual.
Note: When two or more units are set to master,
the unit with the <
> lamp lit in green is
the one that res.
Modeling Flash
1. Modeling Flash from a Master Unit
When the camera’s depth-of-view
preview button is pressed, the ash will
re continuously for 1 sec. This is called
the modeling ash. It enables you to see
the eects of the ash on the subject and
the lighting balance. You can also re the
modeling ash by pressing the charge lamp/
test ash button on Phottix Laso Transmitter
(the operation must be enabled by setting
C.Fn 02).
2. Modeling Flash from a Slave Unit
With EOS digital cameras released since 2012,
you can re the modeling ash from a ash
set as a slave unit. For the operations, see the
ash’s instruction manual.
AF Assist Light
In low light/contrast situation, the Phottix Laso
Transmitter’s built-in Auto Focus Assist Light
will illuminate to assist with AF. The AF Assist
Light on the front of the Transmitter will project
a focusing target on the subject. As a laser
light, the AF assist light features little decay,
great directionality and performance. You can
choose to enable or disable the AF assist light
by setting P. Fn 08.