1. The charge lamp lights when the wireless
shooting (slave) is ready.
2. During wireless shooting, master unit’s
charge lamp will be lit when all slave units are
fully charged.
3. During wireless shooting, you can press the
Transmitter’s charge lamp (test ash button
to re a test ash.
Remote Release from Slave Unit
When performing wireless shooting, Phottix
Laso Transmitter supports remote release
(remote control shooting) from a ash set
or Phottix Laso Receiver as a slave unit. For
operations, see the ash or Phottix Laso
Receiver’s instruction manual.
Note:
When using the remote release function,
the slave unit camera might need a shutter
release cable (available separately) depending
on the camera models.
1) EOS digital cameras since 2012
(excluding EOS 1200D) do not need to use
shutter release cable.
2) EOS cameras before 2012, which are
compatible with E-TTL II/E-TTL autoash
and come with N3 type remote terminal
EOS, a shutter release cable will be needed
for remote release.
Test Flash from a Slave Unit
You can re a test ash from a ash set as
To Next Page
Loading...
