1.Press < > button to set the flash
mode to < >.
2.Set the number of ring group:
While
is displayed, press function
button 2 corresponding to to set
the groups to fire. The setting changes
as follows each time pressing the button:
ALL( ) A/B( ) A/
B/C( ).
3.Select a ring group: Press function button
3 corresponding to
, turn< > to
select the group for which you want to set
the ash output, and press <
> button.
4.Set the ash output: Press function button 3 , turn
<
>to set the ash output and press <
>
button. Repeat step 3and 4 to set the output of all
groups.
5.Take the picture: Each group res at the set ash
output.
To Next Page
Loading...
