3 - 14
Automatic transmission
05_049
- Fit the washer and the nut.
- Insert the specific tool tooth in the hole on the hous-
ing.
- Tighten the 2 screws making sure that the catch is in
contact with the driven pulley axle support.
Specific tool:
Clutch housing lock tool 020473Y
05_050
- Tighten the housing fixing nut to the prescribed torque.
Tightening torque:
Driven pulley shaft nut: 90 - 92 N·m
05_051
- Remove the specific tool
- Insert the 2 remaining fixing screws of the driven pulley
axle support and cross-tighten the 4 screws to the
prescribed torque.
Tightening torque:
Driven pulley axle support fixing
screws: 23 - 26 N·m
05_052
To Next Page
Loading...
