5 - 12
- Oil pressure sensor supply duct
- Oil vapors decantation chamber exhaust.
05_117
05_118
- Refit the blowby reed valve with a new seal gasket.
- Refit the support with gate and tighten the screws to
the prescribed torque.
Tightening torque:
Support screws: 0.3 - 0.4 N·m
05_119
05_093
- Fit a new pump shaft O ring by means of the specific
tool.
- Fit the oil minimum pressure sensor and tighten it to
the presrcibed torque.
Tightening torque:
Oil minimum pressure sensor: 4 - 5 N·m
Specific tools:
Handle 020376Y
15 mm guide 020412Y
Flywheel cover
To Next Page
Loading...
