Name: PIAGGIO Beverly 125
Brand: PIAGGIO
Rating: 5 (1 reviews)

To Next Page

To Previous Page

03_30

Helmet compartment lighting bulb (03_30)

Open the helmet compartment, take out the pressure mounted transparent cover

"D" and replace the bulb.

03_31

Idle adjustment (03_31, 03_32)

Proceed as follows:

1. Rest the vehicle onto its centre-stand and lift the seat (as described in the section

«Accessing the helmet compartment - opening the seat»).

2. Loosen the fixing screws, «A», and remove the carburettor flap.

3. Start the engine, hence tighten or loosen the idle adjusting screw, «B», until the idle

speed is within the prescribed limits, and the rear wheel is not spinning, i.e. the clutch

is not engaged.

Should the adjustment be found difficult to perform, please contact your local PIAG-

GIO Dealer or Authorised Service Station so that a complete CO adjustment may

be carried out.

WARNING

IDLE SPEED MUST BE ADJUSTED WHEN THE ENGINE IS VERY HOT. BEFORE

THIS OPERATION, MAKE SURE THAT THE THROTTLE GRIP HAS THE RECOM-

MENDED BACKLASH. IF BACKLASH IN THE THROTTLE CONTROL TRANS-

3 Maintenance

Other manuals for PIAGGIO Beverly 125

Questions and Answers:

Need help?

Do you have a question about the PIAGGIO Beverly 125 and is the answer not in the manual?

General