03_34
Periods of inactivity (03_34)
We recommend carrying out the following operations:
1. Clean the scooter thoroughly and then cover it with a canvas;
2. With engine off and piston at the bottom dead centre, remove the spark plug, fill
with 1÷2 cm³ of oil (adding more than this quantity is dangerous for the engine). Op-
erate the starter button 1-2 times for roughly 1 second to turn the engine over slowly,
then insert the spark plug again;
3. Drain all the fuel from the scooter; spread antirust grease on the unpainted metal
parts; keep the wheels lifted above the ground by resting the chassis on two wooden
wedges;
4. As regards the battery, follow the instructions in the «Battery» section.
Recommended products
AGIP CITY HI TEC 4T
Oil to lubricate flexible transmissions (throttle control)
Oil for 4-stroke engines
Cleaning the vehicle
Use a low pressure jet of water to soften the caked dirt and mud deposited on the
painted surfaces. Once softened, sponge off mud and dirt using a car body sponge
soaked in a car body shampoo and water solution (2-4% of car shampoo in water).
Then rinse abundantly with water, and dry with a shammy cloth. For the outside of the
engine, use petroleum, a brush and clean cloths. Petrol can damage paintwork. Re-
member that any polishing with silicone wax must always be preceded by washing.
61
To Next Page
Loading...
