Headlight adjustment
Proceed as follows:
- Position the unloaded scooter, in running order
and with the tyres inflated to the prescribed pres-
sure, onto a flat surface 10 m away from a half-lit
white screen; make sure the scooter axis is per-
pendicular to the screen;
- Turn on the headlight and check that the border
of the projected light beam on the screen is not
higher than 9/10 or lower than 7/10 f the height
from the ground to the centre of vehicle headlamp;
- If this is not the case, adjust the headlight by op-
erating the screw «A».
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EURO-
PEAN STANDARDS REGARDING MAXIMUM AND MINI-
MUM HEIGHT OF LIGHT BEAMS. REFER TO THE STATU-
TORY REGULATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.
SAS filters inspection and cleaning
- Remove the flywheel cover.
- Remove the two screws fixing the SAS valve as
shown in the figure and remove the SAS valve and
the O-ring from the support
- Remove the plastic support and the gasket as
shown in the photograph
Maintenance Carnaby 125 - 200
MAIN - 54
To Next Page
Loading...
