pico Technology PicoScope 2000 Series - Environment; Care of the Product

5DO231-11 Copyright © 2006–2022 Pico Technology Ltd. All rights reserved.
User’s Guide PicoScope 2000 Series Oscilloscopes and MSOs
CAUTION
Take care to avoid mechanical stress or tight bend radii for all connected leads. Mishandling will
cause deformation and will degrade performance and measurement accuracy.
2.5 Environment
This product is suitable for indoor or outdoor use, in dry locations only.
Please contact Pico technical support if you would like any advice on integrating a PicoScope into
your own product or application.
WARNING
To prevent injury or death, do not use in wet or damp conditions, or near explosive gas or vapor.
CAUTION
To prevent damage, always use and store your oscilloscope in appropriate environments.
Storage Operating Quoted accuracy
Temperature –20 °C to +60 °C 0 °C to 50 °C 15 °C to 30 °C
Humidity
(non-condensing)
5 to 95 %RH
(non-condensing)
5 to 80 %RH
(non-condensing)
Altitude 2000 m (maximum)
Pollution degree 2 (maximum)
EMC
EN61326-1 basic immunity. The radiated and conducted RF signals
prescribed by this standard may cause interference of up to 4 vertical
divisions peak to peak.
2.6 Care of the product
The product contains no user‑serviceable parts. Repair, servicing, and adjustment require
specialized test equipment and must only be performed by Pico Technology or an approved service
provider. There may be a charge for these services unless covered by the Pico ve‑year warranty.
Inspect the instrument and all probes, connectors, cables and accessories before use for signs of
damage.
To prevent injury or death, do not use the product or an accessory if it appears to be damaged in
any way, and stop use immediately if you are concerned by any abnormal operations.
WARNING
To prevent electric shock do not tamper with or disassemble the oscilloscope, case parts,
connectors or accessories.
When cleaning the oscilloscope, use a soft cloth and a solution of mild soap or detergent in
water. To prevent electric shock, do not allow liquids to enter the oscilloscope casing, as this will
compromise the electronics or insulation inside.