User’s Manual
Page 7
EN
Getting Started
Charging the product
The projector is built in a Li-Polymer battery
for mobile use. Please charge the projector
for 8 hours prior to its first use. Repeat
charging will take around 4 hours.
The battery will be charged only when the projector is not in use (Power off). Connect
one end of the supplied power adapter to DC IN jack and the other end to a power
outlet to start charging.
Exchange the plug (EU, US and etc.) of AC adapter that accommodates the type of
power outlet in your country if it’s different.
Charging LED Indicator
During charging, the LED indicator lights will flash as marquee. When the battery is
fully charged, the LED indicator lights turns to solid blue.
LED indicators
LED Status Indication
3 blue LEDs stay on Power capacity is between 80% to 100%
2 blue LEDs stay on Power capacity is between 45% to 80%
1 blue LED stays on Power capacity is between 10% to 45%
1 blue LED blinks Power capacity is below 10%
LED Marquee
Projector is being charged
3 blue LEDs blink Charging the external mobile device
Power On / Off the Projector
Push the Power button for 2 seconds to turn on the projector.
To power off the projector, push the Power button again for 2 seconds.
Standby mode: Push the Power button for 1 second to turn on/ off the projector lamp
for a short break to save the battery and system reboot time. (The LEDs are still on
when the projector is in standby mode.)
To Next Page
Loading...
Need help?
General
