EasyManua.ls Logo

Pilz PNOZmulti Series - Safety; Intended Use

Pilz PNOZmulti Series
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety
OperatingManualPNOZmc7p
1003050EN02
8
3 Safety
3.1 Intendeduse
ThefieldbusmodulePNOZmc7pisanexpansionmoduleoftheconfigurablecontrolsys
temPNOZmulti.Itisusedforcommunicationbetweentheconfigurablecontrolsystem
PNOZmultiandtheCCLink.
CCLinkisdesignedforfastdataexchangeatfieldlevel.TheexpansionmoduleCCLinkis
apassivesubscriber(Slave)inCCLink.ThebasiccommunicationfunctionswithCCLink
conformtoCCLinkV1.10.Thecentralcontroller(master)readsinputinformationfromthe
slavesandwritesoutputinformationtotheslavesaspartofeachcycle.Aswellasthecyc
licaltransferofusabledata,theexpansionmodulePNOZmc7palsohasdiagnosticand
commissioningfunctions.DatatrafficismonitoredontheMaster/Slaveside.
Theexpansionmodulemayonlybeconnectedtoabaseunitfromtheconfigurablecontrol
systemPNOZmulti(pleaserefertothedocument"PNOZmultiSystemExpansion"forde
tailsofthebaseunitsthatcanbeconnected)
TheconfigurablecontrolsystemPNOZmultiisusedforthesafetyrelatedinterruptionof
safetycircuitsandisdesignedforusein:
} ESTOPequipment
} SafetycircuitsinaccordancewithVDE0113Part1andEN602041
Theexpansionmodulemaynotbeusedforsafetyrelatedfunctions.
Thefollowingisdeemedimproperuseinparticular:
} Anycomponent,technicalorelectricalmodificationtotheproduct
} Useoftheproductoutsidetheareasdescribedinthismanual
} Useoftheproductoutsidethetechnicaldetails(seechapterentitled"TechnicalDe
tails").
NOTICE
EMCcompliantelectricalinstallation
Theproductisdesignedforuseinanindustrialenvironment.Theproduct
maycauseinterferenceifinstalledinotherenvironments.Ifinstalledinother
environments,measuresshouldbetakentocomplywiththeapplicable
standardsanddirectivesfortherespectiveinstallationsitewithregardtoin
terference.
3.2 Systemrequirements
Pleaserefertothe"ProductModifications"documentinthe"Versionoverview"sectionfor
detailsofwhichversionsofthebaseunitandPNOZmultiConfiguratorcanbeusedforthis
product.

Related product manuals