Pilz PSEN ml b 1.1 - Page 12

Overview
Operating Manual PSEN ml b 1.1/2.1/2.2
1003884-EN-12
| 12
} LEDs:
– Supply voltage/fault
– Status of actuator
– Status of guard locking
– Input lights up yellow (without function)
} The bolt in the actuator can be rotated 90° in the actuator housing before the actuator is
installed. As a result, the actuator can be installed vertically or horizontally.
} The safety switch can be expanded with up to three stationary and/or external escape re-
leases (see Order reference: Accessories [ 75]).
The stationary escape release can be extended by a maximum of 50 mm (twice by
25mm).
The external escape releases are available with push/pull cables with a length of between
0.5 and 4 m (50cm increments).
} On small door radiuses, (see Install the safety switch horizontally at a swing
gate [ 33]) the PSENmlactuatorcenterring can be inserted (see Order reference:
Accessories [ 75]).
} The actuator is available in two types (see Order reference: Accessories [ 75]).
– Standard actuator
– Actuator with rounded tip
Standard actuator Actuator with rounded tip