Pilz PSEN ml b 1.1 - Installation on Swing Gate

Installation
Operating Manual PSEN ml b 1.1/2.1/2.2
1003884-EN-12
| 33
8.2.2 Installation on swing gate
[1]
[2]
[2]
Fig.: Swing gate with internal and external hinge
Legend
[1] Safety switch on gate frame
[2] Actuator, installed on swing gate
1. Install the safety switch with the fixing screws of the safety switch in parallel to the
actuator [ 39] or side-on to actuator [ 39] on the gate frame.
2. Use two M5 screws to fix the actuator to the gate.
The actuator should engage smoothly into the safety switch.
Install the safety switch horizontally at a swing gate
Depending on the installation boundary conditions, a larger gate radius may be required
(see diagram).
Please contact Pilz when smaller gate radiuses are required.