Pilz PSEN ml b 1.1 - Installation External Escape Release

Installation
Operating Manual PSEN ml b 1.1/2.1/2.2
1003884-EN-12
| 47
8.5.4 Installation external escape release
1. Remove the security screw [1] using a Torx T10 screwdriver T10.
2. Screw the adapter disk of the escape release with the two hexagon sockets M3x8[3]
on the safety switch with 1,2 - 1,5 Nm (see diagram). The pin of the adapter disk [2]
must be at the place where the security screw of the auxiliary release [1] used to be.
[1]
[2]
[3]
Legend
[1] Security screw of the auxiliary release
[2] Pin in the adapter disk
[3] Hexagon sockets M3x8
3. Screw the escape release with the four raised head screws M3x12 to the adapter disk
with 1,2 - 1,5 Nm (see diagram).