Installation
Operating Manual PSEN ml b 1.1/2.1/2.2
1003884-EN-12
| 51
8.6 Auxiliary release
Install the auxiliary release on the safety switch as described in Installation external escape
release.
} Use an 8 mm spanner to release the button handle.
} Apply a low-strength threadlocker (e.g. a threadlocking adhesive) evenly on the thread of
the piston rod and then turn the red button handle as far as it will go. Max. torque setting:
1 Nm
To activate the auxiliary release the button handle must be unscrewed and then screwed
back on to the piston rod rotated 180°.
To Next Page
Loading...
