Pioneer KRP-500P - [2] PANEL MAIN FACT.

104
KRP-500P
1
2 3 4
A
B
C
D
E
F
1
2 3 4
Contents of the Display item
• P MAIN: Version of the writing data for the Panel Main microcomputer
• MODULE: Version of the writing data for the Module microcomputer
• SEQ PRS: Version of the writing data for the sequence LSI
• DP RX: Version of the writing data for the DP receiver firmware
• DP RX HARD: Version of the hardware for the DP receiver
• PANEL INFO: Information on the display panel
The versions of the microcomputers for the display (incl. those for the display main unit) are indicated on the VERSION (3)
screen. No other layers are nested below this layer, and there are no adjustment items.
Although the description on the VERSION (3) screen is included in the PANEL MAIN FACT. section, this screen actually
belongs to the INFORMATION layer.
[2-1] VERSION (3)
NAIFOMR
EVRSI (N3)O
NPMAI 0–
OMDULE 0–
2SA
2A
0–1U
0
0
1A
2A
01U
.110
ESQ RSP
PDRX
PDRXHARD 0C15
APNEL INFO XXXXXXXX
TION
1
5
10
15
16
1 5 10 15 20 25 30 32
I–N1 3 1010 –NTV HJ–B
[2] PANEL MAIN FACT.
On the PANEL MAIN FACT. menu screen, acquisition of information on and settings for the display main unit can be
performed, as shown in the table below:
No. Indication Description of functions
[2-1] VERSION (3) To indicate the versions of the microcomputers for the display (incl. those for the display
main unit)
[2-2] PM NG INFO. To indicate the shutdown history of the display main unit
[2-3] PM STATE INFO. To indicate temperatures of the display main unit, state of the fans, brightness, and
model information
[2-4] DP_RX INFO.
Data on the DP receiver
[2-5] PM_SETUP (+) To clear the history and perform function settings whose data are not retained after the
unit is turned off
[2-6] PM_BEZEL_SETUP To perform the bezel setup
[2-7] PM_NG_CLEAR
To clear the shutdown history
Operation Items in the PANEL MAIN FACT. Menu
Description of Indications on Each Layer