Pioneer KRP-500P - 5.8 LIST OF RS-232 C COMMANDS

71
KRP-500P
5
6 7 8
5
6 7 8
A
B
C
D
E
F
5.8 LIST OF RS-232C COMMANDS
RS-232C command list
Command Function
Command
Receiving UCOM
Last
Memory
Effective only
during FAY
Remarks
MOD PM
A
B
C
D
Note: While the display is in System Operation mode (SYSS01) with the Media Receiver (MR,) among the received commands via the
RS-232C connector on the display, only the SYS commands are valid.
To enable other RS-232C commands, set the display to Standalone Operation mode (SYSS00).
ABL *** To adjust the upper limit of power MOD
ALM
S00 To enable SD operation of the display main unit PM
S01 To disable SD operation of the display main unit
PM
AP0 S** Addresses L1 and L2 setting
MOD For enabling changed setting, it is necessary to
turn the unit off then back on again.
AP1 S** Addresses L3 and L4 setting
MOD
AP2 S** Addresses U1 and U2 setting MOD
AP3 S** Addresses U3 and U4 setting MOD
APN *** Average number of pulses for 1V MOD
BCP To copy EEPROM data for backup MOD
BSM
S00 Afterimage/Burn-In Reduction mode: OFF
S01 Afterimage/Burn-In Reduction mode: ON
AMP S00 To set audio muting to OFF
S01 To set audio muting to ON
BRA
S01
To set the baud rate for the RS-232C connector on the panel to 1200 bps PM Corresponding to reception via the RS-232C
connector on the display
S02
To set the baud rate for the RS-232C connector on the panel to 2400 bps PM
S03
To set the baud rate for the RS-232C connector on the panel to 4800 bps PM
S04
To set the baud rate for the RS-232C connector on the panel to 9600 bps PM
BZS
S00 Bezel Setup: EP
PM For use by engineers
S01 Bezel Setup: R1 (Black)
PM
S02 Bezel Setup: R2 (White)
PM
S03 Bezel Setup: R3 (Beige)
PM
CAL
To clear the NG (SD) history managed by the Panel Main microcomputer PM
CBU To set Backup setting to “No backup” MOD
CHM To clear hour-meter data MOD
CMT To clear stored maximum-temperature data MOD
CPC To clear the power-on count MOD
CPD To clear the power-down history MOD
CPM To clear pulse-meter data MOD
CSD To clear the shutdown history of the DIGITAL Assy of the display unit MOD
CSF
S00 Color sensor function: OFF
S01 Color sensor function: ON
CSM
S01 Color Space mode 1: Pioneer original standard
S02 Color Space mode 2: In compliance with the EBU standard
CSB *** Color sensor blue coefficient MOD
CSG *** Color sensor green coefficient MOD
CSR *** Color sensor red coefficient MOD
CTP
S00 Color temperature setting: OFF
S01 Color temperature setting: LOW
S02 Color temperature setting: MID LOW
S03 Color temperature setting: MID
S04 Color temperature setting: MID HIGH
S05 Color temperature setting: HIGH
DIZ
S00 Dither/L dither: OFF, noise: OFF
S01 Dither/L dither: ON, noise: ON
S02 Dither/L dither: OFF, noise: ON
S03 Dither/L dither: ON, noise: OFF
DRV
S00 Panel drive-power: OFF
S01 Panel drive-power: ON