Pioneer KRP-500P - Page 106

106
KRP-500P
1
2 3 4
A
B
C
D
E
F
1
2 3 4
MTPFCA
PM .SIONFTATE
TE
T
MP1 :
EMP
+31
31T:
2T:
3T:
:
+31
∗∗∗
AN A LOW
LOW
123 (D/A)
102 (D/A)
(A/D)1023
60+
(C)
(C)
(C)
C)(
F
:AN BF
:
–SE SORN
B
ODE FIN :OR1.L
M
ORY
1
5
10
15
16
1 5 10 15 20 25 30 32
I–N1 3 1010 –NTV HJ–B
Contents of the Display item
• TEMP1: The current display (panel) temperature is indicated. Temperature is in °C (Centigrade).
• TEMP3, T1-T2, T3 (reserved): The current display (unit) temperature is indicated. Temperature is in °C (Centigrade).
• FAN A, B: Controlled state of the fans (HIGH, LOW, STOP), D/A value
• B-SENSOR: A/D value of the Room Light Sensor
• MODEL INFO.: Model information, such as setup status of the bezel
The display (unit) temperatures detected by the temperature sensors, FAN rotating status, the value acquired by
the Room Light Sensor, and settings for the model are indicated.
No other layers are nested below this layer.
[2-3] PANEL MAIN STATE INFORMATION
<DOWN> : Shifting to DP_RX INFO.
<UP> : Shifting to PM NG INFO.
<L/R> : Updating displayed information
g Key operation
MTPFCA
PD_ .RIONFX
RM–
DP
DEV DI:
PVDE I D–:00E
0E0
036–070CA1
360
ORY
1
5
10
15
16
1 5 10 15 20 25 30 32
I–N1 3 1010 –NTV HJ–B
This screen is for use by engineers.
No other layers are nested below this layer.
[2-4] DP-RX INFORMATION
<DOWN> : Shifting to PM_SETUP (+).
<UP> : Shifting to PM STATE INFO.
<L/R> : Updating displayed information
g Key operation