PDP-435PE
63
5678
56
7
8
C
D
F
A
B
E
7.1.3 DIAGNOSIS WITH THE AID OF FACTORY MODE
• Diagnosis with the aid of Factory mode
[ Data on MD-IIC subcategories ]
NNIFOMRI–
– ––––
N1 01 3–NTV S–T1AT
A
1
PNELPD
I
XD–RV
Y–DC CD0027 H54M2
0 052 H35M1
0 009 H05M0
0 004 H30M3
0 000 H23M1
0 000 H00M7
HM
HM
2
YS–US
– ––––
3
SACN
– ––––
4
YD– CDC
– ––––
5
SNC–5V
– ––––
6
7
8
ARDS
O
FRIST SCEOND
1
1
5
10
15
16
510152025303540
NNIFOMRI–
– ––––
N1 01 3–NTV S–T1AT
A
1
PNELPD
I
ADUIO
VOL I C 0 007 H54M2
0 010 H35M1
0 005 H05M0
0 005 H04M5
HM
HM
HM
HM
2
M–DIIC
– ––––
3
TMEP1
– ––––
4
TMEP1
5
6
7
8
O
MIAN SBU
1
1
5
10
15
16
510152025303540
When the Media Receiver is connected, the power-down and shutdown logs can be referred to with OSD. Only the items
useful when servicing the PDP-435PE/PRO-435PU are described here.
How to enter Factory mode using the remote control unit
Power-down log (INFORMATION-PANEL PD)
Please refer to the technical documentation. (Service knowhow is the same as G4 PDP models.)
The last 8 power-down records are held, with the latest power-down displayed at the top. In the FIRST column, the location
where the PD circuit was activated first (location indicated by flashing of the LED during power-down) is indicated, and in the
SECOND column, the location where the PD circuit was activated second is indicated.
Note: There may not be a SECOND PD.
Shutdown log (INFORMATION-PANEL SD)
The last 8 shutdown records are held, with the latest shutdown displayed at the top. If a shutdown occurred because of "MD-
IIC" (communication failure of the module microcomputer IIC), the subcategory is indicated to inform you of with which device
the microcomputer was in the process of communicating when a failure occurred.
OSD Defective communication part
EROM4K IC5206: Module microcomputer EEPROM
EROM2K IC4002: EEPROM for backup
VOLIC IC3502–Volume IC
To Next Page
Loading...
