Pioneer PDP-5050SX - Preparing the Remote Control Unit; Inserting Batteries

06 Preparation
16
En
Preparing the remote control unit
Inserting batteries
1
Open the battery cover.
2
Insert the supplied two AA size batteries.
• The battery polarities must correspond with the (+) and
(–) indicators in the battery compartment.
3
Close the battery cover.
Cautions regarding batteries
• The remote control unit cannot operate the Plasma Display if
the batteries in the unit are empty. When this happens,
replace the batteries with new ones.
• Do not use manganese batteries. When you replace the
batteries, use alkaline ones.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new
batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
• Do not leave dead batteries in the remote control unit;
chemical leakage will occur. If you find any chemical leakage,
wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter
life expectancy due to storage conditions.
• If you will not use the remote control unit for an extended
period of time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE
COMPLY WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTITUTION’S RULES
THAT APPLY IN YOUR COUNTRY/AREA.
1 Hook
• Use hooks, ropes, chains, and fittings that are
available on the market. Recommended hook:
Nominal diameter 8 mm (M8)
Length 12 to 15 mm (1/2 to 5/8 inch)
2 Cord or chain
Fitting
12 to 15 mm
(1/2 to 5/8 inch)
M8
PDK-TS10
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks) to the
Plasma Display.
2
Using strong cords or chains to stabilize it
appropriately and firmly to a wall, pillar, or other
sturdy element.
• Perform this work in the same way on the left and right
sides.
06-PDP5050SX-Eng (14-19) 05.2.25, 0:15 PM16