Pioneer PDP-5050SX - Connecting the Power Cord

06Preparation
English
19
En
Power cord
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power cord
with a ground terminal is used for efficiency protection.
Always connect the power cord to a three-pronged
outlet and make sure that the cord is properly grounded.
• Always turn off the power of the Plasma Display when connecting
the power cord.
• Disconnect the power cord from the power outlet when the Plasma
Display System is not going to be used for a long period of time.
SERVICE ONLY
ANTENNA B
ANTENNA/
CABLE A IN
IN
OUT
S-VIDEO VIDEO
VIDEO
R-AUDIO-L R-AUDIO-L
COMPONENT
VIDEO
COMPONENT
VIDEO
R-AUDIO-L Y C
B /P B C R /P R
YC B /P B C R /P R
VIDEO
Cable
CARD
INPUT 2
DIGITAL OUT
OPTICAL
S-VIDEO INPUT 4 INPUT 3
CONTROL SPEAKERS
OUT
R-AUDIO-L
R-AUDIO-L
HDMI
MONITOR
OUT
AC IN
INPUT 1
Connecting the power cord
Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Noise filter
Partially eliminates noise
caused by the power source.
06-PDP5050SX-Eng (14-19) 05.2.25, 0:15 PM19