10 Adjustments and Settings
36
En
AV Selection
Select from the five viewing options, depending on the current
environment (e.g., room brightness), the type of the current TV
program, or the type of images input from external equipment.
1
Press AV SELECTION.
• The current AV Selection mode appears.
2
Press AV SELECTION again before the displayed mode
disappears.
• The mode is switched in the order; STANDARD,
DYNAMIC, MOVIE, GAME, then USER.
You can also use the menu to change the options.
1
Press HOME MENU.
2
Select “Picture”. ( / then ENTER)
3
Select “AV Selection”. ( / then ENTER)
4
Select the desired option. ( / then ENTER)
AV Selection
STANDARD
DYNAMIC
MOVIE
GAME
USER
Item Description
STANDARD For a highly defined image in a normally
bright room
DYNAMIC For a very sharp image with the maximum
contrast
This mode does not allow manual image
quality adjustment.
MOVIE For a movie
GAME Lowers image brightness for easier viewing.
USER Allows the user to customize settings as
desired. You can set the mode for each input
source.
5
Press HOME MENU to exit the menu.
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the Plasma Display into the standby mode.
Press SLEEP to select the desired time.
• The timer starts counting.
• Each time you press SLEEP, the selection is switched as
below:
(cancel)
30 60 90
120
Off
(minutes)
• The factory default is “Off”.
• To cancel the Sleep Timer, select “Off” by pressing SLEEP.
• Five minutes before the selected time elapses, the remaining time
appears every minute.
You can also use the menu to set the Sleep Timer.
1
Press HOME MENU.
2
Select “Sleep Timer”. ( / then ENTER)
3
Select the desired time. ( / then ENTER)
4
Press HOME MENU to exit the menu.
10-PDP5050SX-Eng (36-40) 05.2.25, 10:46 AM36
To Next Page
Loading...
