Pioneer SA-708 - Adjustments; Idle Current Adjustment; Output Indicator Adjustment

I
TOY
TN
==
CONDITIONS
FREQUENTLY
MISTAKEN
FOR
MALFUNCTIONS
In event of suspected malfunction, check the unit according to the : following table and confirm proper
operation of other connected equipment. If the difficulty cannot be corrected, turn off the power and
contact a Pioneer authorized service center.
@ Does power indicator light on? @ Plug power cord securely into power outlet.
@ Set power switch to ON.
@ Connect properly.
(If all components are connected properly,
check the components themselves).
e Are speakers, tuner, tape deck and other com-
ponents connected properly?
@ Set so that the switch corresponds to the
source.
Is function selector set to correspond to
program source?
@ Set to OFF except for tape playback. Refer to
page 11.
Check tape monitor switch position.
@ Select in accordance with the speaker terminals
to which speakers are connected.
Check speaker selector position.
e@ Set muting switch to OFF, and rotate volume
control clockwise.
Check positions of muting switch and volume
control.
e@ Sound will not be heard for several seconds due
Sound is not heard immediately even though
to actuation of the muting circuit. See page 8.
power switch is set to ON.
e Connect to as to eliminate faulty contacts.
(Noise may decrease when ground wire is con-
nected.)
e Any problem with connected components? @ Correct fault.
e Set tone switch to ON and muting switch to
OFF.
Occasional noise is Are components connected properly?
heard.
Sound quality remains @ Check positions of tone and muting switches.
unaltered.
e Try changing the installation locations of the
turntable and speakers.
e Turntable and speakers are too close to one
another.
Howl caused
when volume is raised.
e@ Installation locations of turntable and speakers @ Do not turn up the bass controls excessively.
are not stable.
PIONEER ELECTRONIC CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153, Japan
U.S. PIONEER ELECTRONICS CORPORATION 8&5 Oxford Drive, Moonachie, New Jersey 07074, U.S.A.
PIONEER ELECTRONIC (EUROPE) N.V. Luithagen-Haven 9, 2030 Antwerp, Belgium
PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia
<79D0O1FOBO1> Printed in Japan (ARB-328-0)