FUEL SELECTOR VALVE.
REMOVAL OF FUEL SELECTOR VALVE.
1. Remove three screws holding selector cover and the screw holding the handle. It will be necessary to
remove side panel to gain access to the selector valve.
2. Remove selector handle and cover.
3. Disconnect fuel lines from the selector valve.
4. Remove fuel valve assembly by removing attaching screws.
INSTALLATION OF FUEL SELECTOR VALVE.
1. Secure the valve to the bulkhead attachment location with attaching screws.
2. Connect the fuel lines to the valve.
3. Install side panel.
4. Install the selector cover with attaching screws.
5. Install the valve control handle with attaching screws.
CLEANING FUEL SYSTEM.
1. To flush the fuel tanks and selector valve, disconnect the fuel line at the injector.
2. Select a fuel tank, turn on the electric fuel pump and flush fuel through the system until it is
determined there is no dirt and foreign matter in the fuel valve or tank. During this operation, agitation of the
fuel within the tank will help pick up and remove any dirt.
3. Repeat this procedure for each tank.
4. When tanks are flushed, clean all filters.
ELECTRIC FUEL PUMP. (Airborne) (PA-28RT-201T)
REMOVAL AND INSTALLATION OF ELECTRIC FUEL PUMP.
The electric rotary vane type fuel pump is mounted in a bracket on the forward side of the firewall. To
remove pump, proceed as follows:
1. Remove engine cowl to gain access to the pump.
2. Remove fuel lines from the pump and disconnect the electrical leads.
3. Remove straps holding pump in position.
4. Do not attempt to disassemble or repair the fuel pump. If fuel pump proves to be defective, it should
be replaced.
5. Reinstall pump in reverse order of removal.
28-20-10
Page 28-11
December l, 1978
2B6
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
To Next Page
Loading...
Need help?
General
