7. Route and connect the electrical Ieads to the appropriate connections on the engine.
8. Connect the tachometer drive cable.
9. Connect exhaust manifold at the turbocharger turbine inlet (“Y” connection) and at each exhaust
manifold slip joint adjacent to No. 1 and 2 cylinders.
—NOTE—
Secure all cables, hoses and wires with clamps and Ty-strap in
the same location as before removal.
10. Install the propeller and spinner per Chapter 61.
11. Service the engine with the proper grade and quantity of oil.
12. Be certain all switches are in the OFF position and connect the battery cables.
13. Install the engine cowling.
14. Make a final check of the security, location and installation of all lines, wires and cables.
15. Perform an operational check of the engine; inspect for leaks and make final adjustments to engine
controls as required.
COWLING.
REMOVAL, OF ENGINE COWLING. (Refer to Figure 71-2.)
1. Release the fasteners securing the upper cowl and then remove the upper cowl.
2. Disconnect fuel drain flex line from the drain valve assembly.
3. Disconnect the nose gear door rods.
4. Support the bottom cowl and remove the screws that attach the cowl to the upper nose cowl, engine
mount and fuselage.
CLEANING, INSPECTION AND REPAIR OF ENGINE COWLING.
1. The cowl should be cleaned with a suitable solvent and then wiped with a clean cloth.
2. Inspect the cowling for dents, cracks, loose rivets, damaged or missing fasteners and damaged
fiberglass areas.
3. Repair all defects to prevent further damage. Fiberglass repair procedures may be accomplished
according to Fiberglass Repairs, Chapter 51.
INSTALLATION OF ENGINE COWLING. (Refer to figure 71-2.)
1. Position the bottom cowl and secure with screw fasteners to the fuselage and engine mount.
2. Position and connect the upper nose cowl to the lower cowl.
3. Install the top cowl with attaching screw fasteners.
4. Attach nose gear door rods.
5. Connect the fuel drain flex line to the drain valve assembly.
Effectivity 71-10-03
PA-28RT-201T Page 71-10
Issued: December 1, 1978
3B23
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL