Page 23 of 37
memory, and then print it (overlay) the logo on the envelope with your print job that may contain addresses
only.
You can access this feature via either the LCD control panel (Main Menu > 8. Image Overlay), or the
Control Panel software (Job Control Tab > Job and Overlay Options). Accessing the feature from the
Control Panel software provides you more options (see the software Help for more information).
5.4 Address Recovery
5.4.1 What is address recovery and how can I access it on the printer?
Address recovery is used when a number of pieces have been jammed or are unusable for some reason
(e.g., low ink), but the majority of the run is either completed or still to be processed. In this situation, you
can use Address Recovery
to print the damaged pieces from the printer memory and then continue.
5.4.2 How many addresses can the Address Recovery buffer of the printer hold?
The address recovery buffer holds up to 100 addresses, depending on field length and size.
5.5 Firmware Download
5.5.1 After I do a firmware update, what other printer adjustments are needed?
Follow directions in Question #7 above or Section A.5 in the Shuttle Head Service Manual (SV61831) for
resetting the printer memory to default values.
Take printer off line and press the Cartridge (+) button. Install new ink cartridges or remove and reinstall
the existing ink cartridges. Follow the LCD prompts to reset ink percentage and align ink cartridges (refer
to the Printer Maintenance chapter in appropriate Operator Guides (see section 1.1.1) for more
information).
Perform the following four maintenance options. You have a choice to do these from either the LCD menu
on the printer or from the Control Panel software on the host PC.
LCD Menu on the printer (Preferred)
Navigate to the Service Menu and perform:
Test Paper Sensor
Left Justify
Envelope Bottom Edge
Print Head Skew
See Section A.4 in the Service Manual for more information.
Control Panel software on the Host PC (Alternate)
From the PC Control Panel, navigate to the Test & Adjust tab and perform:
Calibrate Paper Sensor
Adjust Left Justify Position
Adjust Envelope Bottom Edge
Print Head Skew
Refer to the built-in Help for more information.
On the printer LCD menu, enter the Setup Menu and select Test Print Head. Print the test pattern and
review nozzle performance (see Section A.3 in the Service Manual for more information). Follow the
suggestions listed if problems are evident.
To Next Page
Loading...
