Page 31 of 37
3. Press the Enter key again to go into the A. Feeder type submenu.
4. Use the + key to select Other and press the Enter key to confirm the selection. Make sure the *
symbol appears in front of the selection.
5. Press the Menu key to go back up one level and use + key to scroll down to B. Feeder Signal,
press the Enter key.
6. Use the + key to select appropriate signal type (e.g., On-OFF for the FeedRight feeder) and press
the Enter key to confirm the selection. Make sure the * symbol appears in front of the selection.
7. Press the Menu key to go back up one level and use + key to scroll down to C. Mode, press the
Enter key.
8. Use the + key to select appropriate off-mode (e.g., Normal Off for the FeedRight feeder) and press
the Enter key to confirm the selection. Make sure the * symbol appears in front of the selection.
9. Press the Menu key to go back up one level and use + key to scroll down to D. Signal Polarity,
press the Enter key.
10. Use the + key to select appropriate signal polarity (e.g., Active Off for the FeedRight feeder) and
press the Enter key to confirm the selection. Make sure the * symbol appears in front of the
selection.
11. Press the Menu key to go back up one level and use + key to scroll down to E. Pulse Time
(msec), press the Enter key.
12. Use the + or – key to change the pulse time to a desirable value (e.g., 10ms will work for the
FeedRight feeder) and press the Enter key. Make sure the * symbol appears in front of the pulse
time value. (TIP: press and hold + or – key will increment or decrement the pulse time value
continuously.).
13. Power cycle the machine for the settings to take effect.
9.11 Setup Stacker/Conveyor (Fixed)
1. With printer OFF LINE, enter the Setup Menu by press and hold the MENU key.
2. Use – key to scroll to 3. Conveyor Setup menu and press the Enter key.
3. Press the Enter key again to go into the A. Use Conveyor submenu.
4. Use the + key to select Enable and the Enter key to confirm the selection. Make sure the *
symbol appears in front of the selection.
5. Press the Menu key to go back up one level and use + key to scroll down to B. Conveyor Type,
press the Enter key.
For Stackers such as W985/W986 stacker:
6. Use the + key to select Stacker as Conveyor type and press the Enter key to confirm the
selection. Make sure the * symbol appears in front of the selection.
7. Power cycle the machine for the settings to take effect.
To Next Page
Loading...
