Page 30 of 37
9.7 Set Purge on First Piece (Fixed)
1. With printer OFF LINE, enter the Setup Menu by pressing and holding the MENU key.
2. Use – key to scroll to 10. Pre-Purge menu and press the Enter key.
3. Press the Enter key again to enter A. Purge at Start submenu.
4. Use the + key to select Enable Purge at Start Feature or Disable Purge at Start feature and
press the Enter key to confirm the selection. Make sure the * symbol appears in front of the
selection.
5. Press ONLINE button to put the printer back online.
9.8 Set Periodic Purge (Fixed)
1. With printer OFF LINE, enter the Setup Menu by press and hold the MENU key.
2. Use – key to scroll to 10. Pre-Purge menu and press the Enter key.
3. Use + key to scroll down to B. Periodic Purge submenu and press the Enter key
4. Use the + key to select Enable Periodic Purge feature or Disable Periodic Purge feature and
press the Enter key to confirm the selection. Make sure the * symbol appears in front of the
selection.
5. Press the Menu key to go back up one level and use + key to scroll down to C. Purge Interval,
press the Enter key.
6. Use the + or – key to change the periodic purge interval to a desirable value and press the Enter
key. Make sure the * symbol appears in front of the periodic purge interval value. (TIP: press and
hold + or – key will increment or decrement the periodic purge interval value continuously.)
7. Press ONLINE button to put the printer back online.
9.9 Set Nozzle Keep Alive (Fixed)
1. With printer OFF LINE, enter the Setup Menu by press and hold the MENU key.
2. Use – key to scroll to 10. Pre-Purge menu and press the Enter key.
3. Use + key to scroll down to D. Nozzle Keep Alive submenu and press the Enter key.
4. Use the + key to select Enable Periodic Purge feature or Disable Periodic Purge feature and
press the Enter key to confirm the selection. Make sure the * symbol appears in front of the
selection.
5. Press ONLINE button to put the printer back online.
9.10 Setup External Feeder (WF96 Only)
1. With printer OFF LINE, enter the Setup Menu by press and hold the MENU key.
2. Use – key to scroll to 2. Feeder Setup menu and press the Enter key.
To Next Page
Loading...
