Page 32 of 37
For Conveyors:
6. Use the + key to select Conveyor as Conveyor type and press the Enter key to confirm the
selection. Make sure the * symbol appears in front of the selection.
7. Press the Menu key to go back up one level and use + key to scroll down to C. Activate Polarity,
press the Enter key.
8. Use the + key to select appropriate polarity and press the Enter key to confirm the selection.
Make sure the * symbol appears in front of the selection.
9. Press the Menu key to go back up one level and use + key to scroll down to D. Conveyor On
Time, press the Enter key.
10. Use the + or – key to change the on time to a desirable value and press the Enter key. Make sure
the * symbol appears in front of the value. (TIP: press and hold + or – key will increment or
decrement the value continuously.).
11. Power cycle the machine for the settings to take effect.
9.12 Address Recovery
The Address recovery feature is accessed on the control panel Main Menu.
1. With printer OFF LINE, enter the Setup Menu by press and hold the MENU key.
2. Use – key to scroll to 5. Address Recovery menu and press the Enter key. You now have two
choices:
Get Address (batch) option.
This option allows you to retrieve any address in the data buffer. The first 16 characters of the
selected address are shown. The characters will be 'cryptic' in a Windows (non-DOS) application.
Use the + or - keys to scroll through the addresses. When you have reached the end of the
addresses in the recovery buffer, None to Recover displays.
Get Address (interactive) option
The last address printed (N) is reprinted when the + key is pressed. If the + key is pressed again,
the N-1 address is reprinted, and so on until the recovery buffer is exhausted.
3. When the printer goes back on-line, printing resumes at the recovered page.
9.13 Print Driver Deletion
Delete the existing driver as follows:
1. Click Start > Settings > Printers and Faxes. (XP)
2. Select the printer model you wish to delete.
3. Hit the Delete key. Click Yes to the Are You Sure
prompt.
4. Select menu item File > Server Properties
Click on the Drivers tab.
To Next Page
Loading...
