4 /20
Use, maintenance and calibration
M0147E
3 SAFETY INSTRUCTIONS
3.1 SAFETY WARNINGS
Mains - pre-
liminary checks
before instal-
lation
ATTENTION
You must avoid any contact between the electrical power supply and the fluid
that needs to be FILTERED.
Maintenance
control
Before any checks or maintenance work are carried out, disconnect the power
source.
FIRE AND
EXPLOSION
Connect the metal parts of the device to earth
Stop operation immediately if static sparking occurs or if you feel a shock. Do not use
equipment until you identify and correct the problem.
Keep a working fire extinguisher in the work area.
EQUIPMENT
MISUSE
Misuse can
cause death or
serious injury
!
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
Do not leave the work area while equipment is energized or under pressure.
Turn off all equipment when equipment is not in use.
Do not alter or modify equipment. Alterations or modifications may void agency
approvals and create safety hazards.
Route hoses and cables away from traffic areas, sharp edges, moving parts, and
hot surfaces.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
TOXIC FLUID
OR FUMES
HAZARD
Read MSDS’s to know the specific hazards of the fluids you are using.
Store hazardous fluid in approved containers, and dispose of it according to ap-
plicable guidelines.
Prolonged contact with the treated product may cause skin irritation: always
wear protective gloves during dispensing.
3.2 FIRST AID RULES
SMOKING
PROHIBITED
When operating the system and in particular during refuelling, do not smoke
and do not use open flame.
3.3 GENERAL SAFETY RULES
Essential
protective
equipment
characteristics
Wear protective equipment that is:
suited to the operations that need to be performed;
resistant to cleaning products.
Personal
protective
equipment that
must be worn
Safety shoes;
Close-fitting clothing;
Protective gloves;
Safety goggles;
Protective
equipment
Instruction manual
To Next Page
Loading...
