5/124
5 /20
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
K600
3.4 PACKAGING
FOREWORD
K600 comes packed in a cardboard box with a label indicating the
following data:
1 - contents of the package
ACCESS 85
F00702000
ACCESS 85
F00702000
F00702000
F00702000
2 - weight of the contents
3 - description of the product
3.5
PACKAGE CONTENTS/PRE-INSPECTION
FOREWORD
To open the packaging, use a pair of scissors or a cutter, being careful not to damage the
dispensing system or its components.
NOTE
In the event that one or more of the components described below are missing
from inside the package, please contact Piusi inc technical support.
WARNING Check that the data on the plate correspond to the desired specifications.
In the event of any anomaly, contact the supplier immediately, indicating
the nature of the defects. Do not use equipment which you suspect might
not be safe.
4 KNOWLEDGE K600
FOREWORD
K600 – meter and pulser versions - represents a family of meters developed to
satisfy a wide range of requirements for the control, measurement, dispensing
and transfer of lubricating oils and fuels.
measurement
principle
Its measurement principle is based on elliptical gears that provide high accuracy
over a wide range of flow rates together with reduced loss of head. The fluid
passing through the instrument turns the gears whose rotation transfers con-
stant “fluid units”. The exact measurement of the fluid dispensed is carried out
by counting the rotations of the gears and, thus, the “fluid units” transferred. The
magnetic coupling, consisting of magnets installed in the gears and a magnetic
switch located outside the measuring chamber, guarantees the seal of the mea-
suring chamber and ensures the transmission of the impulses generated by the
rotation of the gears to the microprocessor.
The meter housing is manufactured of extruded aluminium and is furnished with
external guides for a practical and simple installation. The various models are
differentiated by the length of the housing, which is related to their ability to func-
tion at higher flow rates.
The meter body is made of die-cast aluminium and fitted with connections for the
installation of threaded flanges, suitable for any type of tubing.
At the inlet opening, a filtering disk of stainless steel mesh is installed, which can
be accessed from the outside by removing the flange close to the flow inlet side.
operating
modes
Normal Mode: Mode with display of Partial and Total dispensed quantities
Flow Rate Mode: Mode with display of Flow Rate, as well as Partial dispensed
quantity
The METER features a non-volatile memory for storing the dispensing data, even
in the event of a complete power break for long periods.
To Next Page
Loading...
