7/124
7 /20
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
K600
All K600/2/3 meters are factory set with a calibration factor called FACTORY K
FACTOR which is set according to the used fluid (diesel fuel or oil of SAE10 W40
type), for optimal measurement performance.
Calibration settings can be changed following the instructions in this manual, but
you can return to the factory calibration at any time.
Battery hous-
ing
The METER is powered by two standard type 1.5 V batteries (size N).
The battery housing is closed by a threaded watertight cap that can be easily
removed for quick battery change.
4.2 VERSION PULSER
The PULSER version is a pulse emitter (reed bulb) which translates the magnetic field variations generated
by gear rotation into electric pulses to be sent to an external receiver. The receiver is to be connected accord-
ing to the enclosed diagram. The pulser does not need any independent electric power supply, as it is directly
powered by the receiver connection.
The issued pulse type is represented by a square wave generated by the voltage variation - see the following
diagram:
The device calibration is carried out by means of the
external pulse receiver.
0
PULSE
4.3 USERS BUTTONS
FOREWORD
The METER features two buttons (RESET and CAL) which individually perform
two main functions and, together, other secondary functions.
MAIN
FUNCTIONS
PERFORMED
- for the RESET key, resetting the partial register and Reset Total
- for the CAL key, entering instrument calibration mode
SECONDARY
FUNCTIONS
Used together, the two keys permit entering configuration mode where the de-
sired unit of measurement can be set.
LEGEND CALIBRATE MEANS PERFORMING ACTIONS ON THE METER KEYS.
BELOW IS THE LEGEND OF THE SYMBOLS USED TO DESCRIBE THE
ACTIONS TO BE PERFORMED
Short pres-
sure of cal
key
CAL
Long pres-
sure of cal
key
CALCAL
CAL
Short
pressure of
reset key
RESET
Long pres-
sure of
reset key
To Next Page
Loading...
