Pixsys ATR 902 User Manual

22 - ATR902 - User manual
16
sp. fu .
Special Functions
Enables simple thermoregulator function and manual setting of output
percentage.
di s .
(Disabled) No function available. > Default.
tH e r.
(Thermoregulator) Enables simple thermoregulator function.
man.
(Manual) Enables manual mode.
tH. m a .
(Thermoregulator and Manual) Enables both simple thermoregula-
tor and manual function.
17
H Ld . F.
Hold Function
Enables “Hold” function; allows to hold the cycle and modify setpoint by
keyboard.
di s .
(Disabled)
“Hold” function disabled. > Default.
En.
(Enabled)
“Hold” function enabled.
18
cy. a u .
Cycles Available
Selects number of available cycles.
1…15 cycles. > Default: 15.
19
b.pr.c.
Block Programming Cycles
Selects number of cycles that the user cannot modify (these can be pre-
programmed by the manufacturer/installer to avoid wrong progamming).
Ex.: selecting 3 the programming of the rst 3 cycles is locked.
0…15 locked cycles. > Default: 0.
20
w.t.s.e.
Waiting Time Step End
Selects time for step end waiting in hh.mm.
00.00 Step end waiting excluded
00.01…24.00 hh.mm. > Default: 01.00.
21
m.G.s . e.
Max. Gap Step End
Selects max. gap for step end waiting activation. When the dierence
between setpoint and process is lower than this parameter, the controller
switches to the next step (also without waiting for the time programmed on
parameter 36
w.t.s.e
)
0…200 degrees. > Default: 5.
22
r.i . cY.
Recovery Interrupted Cycle
Enables the interrupted cycle recovery function.
0 Cycle recovery disabled
1 Cycle recovery enabled with automatic gradient. > Default.
2…1000 degrees/hour. Select recovery gradient.

Pixsys ATR 902 Specifications

General

Brand	Pixsys
Model	ATR 902
Category	Controller
Language	English