Pixsys DRR244 - Page 42

42 - DRR244 - User manual
201 A.5.L.L. Alarm 5 Lower Limit
Lower limit selectable for the alarm 5 setpoint.
-9999..+30000 [digit
1 p. 54
] (degrees for temp. sensors). Default 0.
202
A.5. u . L. Alarm 5 Upper Limit
Upper limit selectable for the alarm 5 setpoint.
-9999..+30000 [digit
1 p. 54
] (degrees for temp. sensors). Default 1750.
203
a .5. re. Alarm 5 Reset
Alarm 5 contact reset type (always automatic if
A L . 5 . F. = c. A ux ).
A. r Es. Automatic reset (Default)
M. r Es. Manual reset (manual reset by keyboard or by digital input)
M.r Es.S. Stored manual reset (keeps the output status also after a power failure)
A. r Es.t. Automatic reset with timed activation. The alarm remains active for the time set on the
parameter 206
a.5. d e. , even if the conditions generating it are missing. To be able to act
again, the alarm conditions must disappear.
204
A.5.S. e. Alarm 5 State Error
Alarm 5 output status in case of error.
If the alarm output is digital (SSR):
off Digital output OFF. Default on Digital ouput ON.
If the alarm output is 0-10V:
0 V 0 V. Default 10 v 10 V.
If the alarm output is 0-20 mA or 4-20 mA:
0 ma 0 mA. Default
4 ma 4 mA.
20 ma 20 mA.
21.5 m a 21.5 mA.
205
rES. Reserved
Reserved parmeter
206 a .5. d e. Alarm 5 Delay
Alarm 5 Delay.
-60:00..60:00 mm:ss (hh:mm if
A L . 5 . F. = c. a ux ). Default: 00:00.
Negative value: delay when exit alarm status.
Positive value: delay when enter alarm status
207
A.5.S. p. Alarm 5 Setpoint Protection
Allows or not to change the alarm 5 setpoint.
FrEE Editable by the user (Default)
Lock Protected
Hid E Protected and not visualized
208
A.5.Lb . Alarm 5 Label
Selects the message displayed in case of alarm 5 intervention.
dis a b. Disabled. (Default) 0.
lb. 01 Message 1 (see table on paragraph .)
..
lb. 20
Message 20 (see table on paragraph .)
u s e r.l. Custom message (modifiable by the user through the App or via modbus)
209÷212 Reserved Parameters - Group K
Reserved parameters - Group K