Pixsys DRR244 - Page 43

User manual - DRR244 - 43
GROUP L -
res
- Reserved
213÷230 Reserved Parameters - Group L
Reserved parameters - Group L
GROUP M -
d.i. 1
- Digital input 1
231 d .i .1. f. Digital Input 1 Function
Digital input 1 functioning.
diS a b. Disabled (Default)
2 t. s w. 2 Setpoints Switch
2 t.s w.i. 2 Setpoints Switch Impulsive
3 t.s w.i. 3 Setpoints Switch Impulsive
4 t.s w.i. 4 Setpoints Switch Impulsive
st./s t. Start / Stop
rUn Run
HoLd Lock conversion (stop all conversions and display values)
tune Performing manual tune
a u . m a .i. Automatic / Manual Impulse (if enabled on parameter 48 or 67)
a u.m a.c. Automatic / Manual Contact (if enabled on parameter 48 or 67)
a c t.tY. Action Type. Cooling regulat. if D.I. is active, otherwise heating reg.
A.i. 0 Analogue Input 0. Set AI to zero
M. reS. Manual reset. Reset the outputs if selected as manual reset.
t.1.r u n Timer 1 run. The timer 1 count with activated D.I.
t.1. s.E. Timer 1 Start End. D.I. starts and stops the timer 1(impulsive)
t.1.S t a. Timer 1 Start. D.I. starts the timer 1(impulsive)
t.1. E n d Timer 1 End. D.I. stops the timer 1(impulsive)
t.2.r u n Timer 2 run. The timer 2 count with activated D.I.
t.2. s.E. Timer 2 Start End. D.I. starts and stops the timer 2(impulsive)
t.2.S t a. Timer 2 Start. D.I. starts the timer 2(impulsive)
t.2.En d Timer 2 End. D.I. stops the timer 2(impulsive)
Lo.cfG. Lock configuration and setpoints.
u p. k e y Simulates the functioning of up key.
d o w n.k. Simulates the functioning of down key.
fnc. k. Simulates the functioning of fnd key.
s et. k. Simulates the functioning of set key.
ext. a l. External alarm. The controller goes on STOP and the alarms will be disabled. The
controller does not return to START automatically: for this operation, the user’s
intervention is required.
232
d.i.1.c. Digital Input 1 Contact
Defines the resting contact of the digital input 1.
n.o pen Normally open (Default)
n.cLos. Normally closed
233÷238 Reserved Parameters - Group M
Reserved parameters - Group M