Pixsys DRR244 - Page 49

User manual - DRR244 - 49
GROUP V -
ser.
- Serial
318 s L. a d . Slave Address
Selects slave address for serial communication.
1...254. Default: 247.
319
bd. rt. Baud Rate
Selects baudrate for serial communication
1. 2 k 1200 bit/s
2.4 k 2400 bit/s
4.8 k 4800 bit/s
9.6 k 9600 bit/s
19.2 k 19200 bit/s (Default)
28.8 k 28800 bit/s
3 8 .4 k 38400 bit/s
57.6 k 57600 bit/s
115.2k 115200 bit /s
320
s . p. p. Serial Port Parameters
Selects the format for the modbus RTU serial communication.
8-N-1 8 bit, no parity, 1 stop bit (Default)
8-E-1 8 bit, even parity, 1 stop bit
8-o-1 8 bit, odd parity, 1 stop bit
8-N-2 8 bit, no parity, 2 stop bit
8-E-2 8 bit, even parity, 2 stop bit
8-o-2 8 bit, odd parity, 2 stop bit
321
se. d e. Serial Delay
Selects serial delay
0...100 ms. Default: 5 ms.
322
o f f.L. Off Line
Selects the off-line tine. If there is no serial communication during the selected time, the
controller switches-off the command output.
0 Offline disabled (Default)
0.1-6 0 0.0 tenths of second.
323÷327 Reserved Parameters - Group V
Reserved parameters - Group V