Advanced Settings Menu
52 EP4650/EP5550 User Manual
Flesh Tone
This feature is used to amplify all colors except that of people’s faces.
Options: Off, Low, Medium and High (Video Mode only)
IRFM
Creates slight frame motion to help avoid image retention.
Options: On
Baud Rate
Options: 115200, 38400, 19200, 9600
Smart Light Control
Options: Off, DCR, Light Sensor
Wake Up From Sleep
Allows you to configure the display to “wake up” when it receives a digital signal
through the DisplayPort, HDMI or DVI connectors. With VGA Only, the display can
only “wake up” by sending an analog video signal through the VGA connector.
Options:
Never Sleep
- The display will never enter a power saving mode.
VGA Only
- The display will enter a power saving mode if it cannot sync for five
minutes with the DisplayPort, HDMI or DVI. If the sync is present, the display
will “wake up” again.
VGA, Digital, RS232
- The display will enter a power saving mode if it cannot
sync for five minutes with any source.
Ethernet Setup
Configure Network settings. See "Setting Up Email Alerts" on page 69 for more
information.
Multi-Display Control
Used for displaying one image across multiple displays.
Factory Reset
Restores all settings to their defaults.
Options: No, Yes
To Next Page
Loading...
