IP-based 8-port Switched Power Manager with 2 Cascaded Ports
IPM-8221
- 43 -
Appendix A: Safety Instructions
General
This product is for indoor use only.
Read all of these instructions. Save them for future reference.
Follow all warnings and instructions marked on the device.
Do not place the device on any unstable surface (cart, stand, table, etc.). If the device falls,
serious damage will result.
Do not use the device near water.
Do not place the device near, or over, radiators or heat registers.
The device cabinet is provided with slots and openings to allow for adequate ventilation. To
ensure reliable operation, and to protect against overheating, these openings must never be
blocked or covered.
The device should never be placed on a soft surface (bed, sofa, rug, etc.) as this will block its
ventilation openings. Likewise, the device should not be placed in a built in enclosure unless
adequate ventilation has been provided.
Never spill liquid of any kind on the device.
Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use
a damp cloth for cleaning.
The device should be operated from the type of power source indicated on the marking label. If
you are not sure of the type of power available, consult your dealer or local power company.
This equipment is designed to be equipped with 100- 230V alternating IT power distribution
system.
To prevent damage to your installation it is important that all devices are properly grounded.
The device is equipped with a 3-wire grounding type plug. This is a safety feature. If you are
unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do
not attempt to defeat the purpose of the grounding-type plug. Always follow your local/national
wiring codes.
Do not allow anything to rest on the power cord or cables. Route the power cord and cables so
that they cannot be stepped on or tripped over.
To help protect your system from sudden, transient increases and decreases in electrical power,
use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).
Position system cables and power cables carefully; Be sure that nothing rests on any cables.
When connecting or disconnecting power to hot pluggable power supplies, observe the following
guidelines:
Install the power supply before connecting the power cable to the power supply.
Unplug the power cable before removing the power supply.
To Next Page
Loading...
Need help?
General