Need help?Do you have a question about the Planet IGSW-24040T and is the answer not in the manual?
General| Switch Architecture | Store-and-Forward |
|---|---|
| Jumbo Frame | Up to 9K bytes |
| Weight | 2.5 kg |
| Ports | 24 x 10/100/1000BASE-T |
| MAC Address Table | 8K entries |
| Power Supply | Internal power supply |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -40°C to 70°C |
| Uplink Ports | 4 x 100/1000BASE-X mini-GBIC/SFP slots |
| Humidity | 5% to 95% (non-condensing) |
Details the environmentally hardened design and key features for industrial networks.
Outlines the physical ports, industrial conformance, Layer 2 features, Quality of Service, and security aspects.
Provides detailed technical specifications for hardware, Layer 2 functions, and standards compliance.
Describes the switch's front panel, LED indicators, and rear panel components.
Provides step-by-step instructions for desktop and rack mounting the switch.
Explains how to access and utilize the switch's web interface for configuration.
Details how to configure and manage the switch using an external SNMP application.
Introduces the main web interface, panel display, and functions menu.
Explains how to configure the switch's IP address, subnet mask, and gateway.
Details how to manage user accounts, including adding, editing, and deleting users.
Guides through the process of updating the switch's firmware using the web interface.
Details the configuration for SNMP modes, versions, and community strings.
Explains how to configure port connection settings like speed, duplex, and flow control.
Details the configuration and status of Link Aggregation Control Protocol (LACP).
Details the configuration of port VLAN settings, including tagged and untagged frames.
Details the configuration settings for STP, RSTP, and MSTP protocols.
Details the configuration options for IGMP snooping, including global and per-VLAN settings.
Details how to configure QoS settings for each individual port.
Covers the configuration of Access Control Lists (ACLs), including ACE definitions.
Details the process of configuring Access Control Entries (ACEs) with various parameters.
Details how to configure the authentication method for system administration access.
Covers the configuration of IEEE 802.1X and MAC-based authentication systems.
Configures Port Security Limit Control to limit the number of users on a port.
Explains how to use PING and IPv6 PING for troubleshooting IP connectivity issues.
Describes how to access the switch's Command Line Interface (CLI) via console or Telnet.
Details commands for IP configuration, including IP setup, ping, and DNS settings.
Provides commands for managing ports, such as port configuration, mode, and flow control.
Configures port security limit control, including mode, aging, and action on limit breach.
Guides users through quickly setting up QoS Control Lists (QCL).
Loads new firmware onto the switch from a TFTP server.
Provides solutions for troubleshooting when the Link LED is not lit.
Offers steps to diagnose and resolve network connectivity issues.
Explains how to reset the IP address or admin password using the hardware reset button.
To Next Page
