Planet IGSW-24040T - SNMP Trap Configuration

User’s Manual of IGSW-24040T
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
4.3.4 SNMP Trap Configuration
Configure SNMP trap on this page. The SNMP Trap Configuration screen in Figure 4-3-3 appears.
Figure 4-3-3 SNMP Trap Configuration Page Screenshot
The page includes the following fields:
Object Description
 Trap Mode
Indicates the SNMP trap mode operation. Possible modes are:
Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.
 Trap Version
Indicates the SNMP trap supported version. Possible versions are:
SNMP v1: Set SNMP trap supported version 1.
SNMP v2c: Set SNMP trap supported version 2c.
SNMP v3: Set SNMP trap supported version 3.
 Trap Community
Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.
 Trap Destination
Indicates the SNMP trap destination address.
82