User’s Manual of IGSW-24040T
Security Network ACL Rate
Description:
Set or show the ACL rate limiter.
Syntax:
Security Network
ACL
Rate [<rate_limiter_list
>] [<packet_rate>]
Parameters:
<rate_limiter_list>: Rate limiter list (1-15), default: All rate limiters
<packet_rate> : Rate in pps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k)
Default Setting:
1
Example:
Set rate limit value in 1024k for port 1
SWITCH/>security network acl rate 1 1024k
Security Network ACL Add
Description:
Add or modify Access Control Entry (ACE).
If the
ACE ID parameter <ace_id> is specified and an entry wi
th this ACE ID already exists, the ACE will be modified. Otherwise, a new ACE will be added. If the ACE ID is not specified, the next available ACE ID will be used.
If the next
ACE ID parameter <ace_id_next> is specified, the
ACE will be placed before this ACE in the list. If the next ACE ID is not specified, the ACE will be placed last in the list.
If the Switch keyword is used, the rule applies to all ports. If the Port keyword is used, the rule applies to the specified port
only. If the Policy keyword is used, the rule applies to all ports configured with the specified policy. The default is that the
rule applies to all ports.
Syntax:
Security Network
ACL
Add [<ace_id>] [<ace_id_next>] [switch
| (port <port>) | (policy <policy>)] [<vid>] [<tag_prio>] [<dmac_type>] [(etype [<etype>] [<smac>] [<dmac>]) | (arp [<sip>] [<dip>] [<smac>] [<arp_opcode>] [<arp_flags>]) |
(ip [<sip>] [<dip>] [<protocol>] [<ip_flags>]) | (icmp [<sip>] [<dip>] [<icmp_type>] [<icmp_code>] [<ip_flags>]) | (udp
[<sip>] [<dip>] [<sport>] [<dport>] [<ip_flags>]) | (tcp [<sip>] [<dip>] [<sport>] [<dport>] [<ip_flags>] [<tcp_flags>])]
391
To Next Page
Loading...
Need help?
General