User’s Manual of WGS Managed Series
Magnet Installation of WGS-4215-16P2S
There are six holes on the unit, using six round magnets to install. Please refer to the following.
Step 1: Turn the switch to the back and place the six round magnets with holes on the back of the switch where the holes are.
Step 2: Turn the switch to front and push the plastic bolts into the holes to secure the magnets.
Step 3: One last round magnet should be fixed in the middle of the switch.
Step 4:Now the you can place the switch on to any magnetic surface.
To Next Page
Loading...
