77 78
Mini100/Mini2
Mini100/Mini2
8. Click on the Add Port button. Now, select Other and choose “PS Port” in
the field below. Click on the OK button to continue.
※ The PS Port item will not be shown if the utility is not installed properly.
Please go to Section 3-1 in Chapter 3 and install the program using “Setup
Diskette”.
9. A window labeled “Add Port” will be displayed. Click on the IPX tab.
After a while, the wizard detects your print server on the network. Click
on the print server name (under Device Name) and click on the OK
button.
※ If the wizard cannot detect your print server, refer to Section 4-1-b in
Chapter 4 and check whether IPX protocol has been installed. If the same
problem persists even though the protocol is already there, check whether
“ N e t Ware Network Client” has been installed. If not, add this Client
component.
To Next Page
Loading...