Plasson PFS Monomatic - Inv. Number

50
EN001 H01
12.6.2 Inv. number
The inventory number can be defined to identify the electrofusion control unit in your stock. The inventory
number can be defined to identify the electrofusion control unit in your stock. You can use the displayed
letter field for input or use a barcode together with the reading pen/scanner. The entered inventory number
will be shown on the reports.
Step Action
1 Accessing the setting of the inventory number
1.1
Select the entry "Inv. number." in the system configuration, using the ▲- and ▼-buttons.
1.2
Press the enter button to access the setting of the inventory number.
2 Setting the inventory number
2.1
Use the letter field for input of the desired inventory number.
Setting the inventory number with the help of the letter
field.
For further information on how to operate the letter field read chapter 12.1 "Using the letter field to
enter data
". After the input of the inventory number press the green start button once to accept the
input and when the following confirmation prompt "Are you sure ?"is displayed press the green
start button once again to confirm. You can abort the input by pressing the red stop button.
By default the device number of the electrofusion control unit is set as inventory number.
00015
Inv. number
ABCDEFGHIJKLMNOPQRST