Plasson PFS Monomatic - Job no; South

EN001 H01
53
12.6.7 Job no.*
If this function is activated, a prompt for the input/selection of job number, under which the report will be
stored, is displayed after connecting a fitting. The job number can consist of numbers and letters.
Step Action
1 Accessing the "Job no." option
1.1
Select the entry "Job no." in the system configuration, using the ▲- and ▼-buttons.
2 Changing the "Job no." option
2.1
The ◄ ► buttons are used to move the marking (*) from the "activated" (+) column to the
„deactivated“ (-) column and vice versa.
For further information please read chapter 12.2 „Job no.*“.
2.2
After having this option changed in the system configuration press the green start button to accept
the change and acknowledge the following safety prompt "Are you sure?"by again pressing the
green start button.
You can abort the input by pressing the red stop button.
*) Only with electrofusion control units that have data recording capability.
12.6.8 South*
If this option is activated the automatic changeover between summer and winter time will be done like on the
southern hemisphere. Deactivate this option if you are on the northern hemisphere.
Step Action
1 Accessing the "South" option
1.1
Select the entry "South" in the system configuration, using the ▲- and ▼-buttons.
2 Changing the "South" option
2.1
The ◄ ► buttons are used to move the marking (*) from the "activated" (+) column to the
„deactivated“ (-) column and vice versa.
2.2
After having this option changed in the system configuration press the green start button to accept
the change and acknowledge the following safety prompt "Are you sure?"by again pressing the
green start button.
You can abort the input by pressing the red stop button.
*) Only with electrofusion control units that have data recording capability.