Plasson PFS Monomatic - Cont. Numbers; Clamping

54
EN001 H01
12.6.9 Cont. numbers*
If this option is activated, the reports will be numbered consecutively. If this option is deactivated, the
numbering for each job number begins at 0001.
Step Action
1 Accessing the "Cont. numbers" option
1.1
Select the entry "Cont. numbers" in the system configuration, using the ▲- and ▼-buttons.
2 Changing the "Cont. numbers" option
2.1
The ◄ ► buttons are used to move the marking (*) from the "activated" (+) column to the
„deactivated“ (-) column and vice versa.
2.2
After having this option changed in the system configuration press the green start button to accept
the change and acknowledge the following safety prompt "Are you sure?"by again pressing the
green start button.
You can abort the input by pressing the red stop button.
*) Only with electrofusion control units that have data recording capability.
12.6.10 Clamping
If this option is activated, another prompt appears before the prompt "Is the pipe scraped and clamped?"
specifically asking "Pipes clamped?".
Step Action
1 Accessing the "Clamping" option
1.1
Select the entry "Clamping" in the system configuration, using the ▲- and ▼-buttons.
2 Changing the "Clamping" option
2.1
The ◄ ► buttons are used to move the marking (*) from the "activated" (+) column to the
„deactivated“ (-) column and vice versa.
2.2
After having this option changed in the system configuration press the green start button to accept
the change and acknowledge the following safety prompt "Are you sure?"by again pressing the
green start button.
You can abort the input by pressing the red stop button.
Only if this option is available in your electrofusion control unit.