Plasson PFS Monomatic - Function menu

EN001 H01
35
12. Function menu
Different variants of the electrofusion control unit
This instruction manual describes several different variants of the electrofusion control unit. These
variants differ in the range of available functions and in the number of menu entries. The
differences are pointed out where necessary. Please check which variant you have.
Step Action
1 Displaying the function menu
1.1
When the main display is shown, press the enter on the keypad. The function menu is displayed:
Main display
2 The function menu
2.1.
After pressing the enter button the function menu will be displayed.
Display of the function menu
The menu contains a list of all available functions. The symbol > is the selection indicator that
marks the entry that is selected or activated when the enter button is pressed.
▲▼
These buttons move the selection indicator up and down.
Enter button
The enter button selects the function marked by the selection
indicator >.
Red stop button
Abort and return to the main display
The following table shows the available functions.
Function Description Page
Job no.
Entering a job number (commission number)*
37
USB
Data transfer to a USB memory stick or printout*
38
Erase reports
Erasing the reports per job number*
45
Contrast
Setting of the display contrast
46
System config.
System configuration options
47
*) Only with electrofusion control units that have data recording capability.
Connect Fitting
+++++Job number+++++
Report number 3
>Job no.
USB
Erase reports