Section 2. Installing the PX-230A Internal ATAPI Drive
12 PX-230A Installation and Users Manual
Open the Computer and Prepare for
Installation
To determine whether your PX-230A will be a Master or a Slave, open
your computer and examine the IDE connections to the motherboard.
To open the computer:
1. Before proceeding, make sure the power to your computer and any
external peripherals is OFF and your computer is UNPLUGGED
from its power source.
2. Remove your computer’s cover, following the directions provided by
your computer’s manufacturer. Typically, this involves loosening or
removing several screws on the back panel of your computer and
sliding off the cover. See Figure 3 for an example.
Figure 3: Removing a typical computer's cover
To Next Page
Loading...
