Section 2. Installing the PX-230A Internal ATAPI Drive
26 PX-230A Installation and Users Manual
To mount the PX-230A drive:
1. Make sure the power to your computer and any external peripherals
is turned OFF and your computer is UNPLUGGED from its power
source.
2. If you haven't already removed the cover from your computer,
remove it now, following the directions provided by your computer’s
manufacturer. Typically, this involves loosening or removing several
screws on the back panel of your computer and sliding off the cover.
See Figure 3 for details.
3. Remove the cover panel from the bay that will hold the drive. To
remove the cover panel, pop it out by pressing outward lightly. (In
some older computers, you may have to remove screws that hold the
panel in place.)
Figure 13: Removing the cover panel from a bay
To Next Page
Loading...
